Check the water circuit and circuit before turning it on. The boot sequence is:
En primer lugar, turn on the incoming power and turn on the key switch. En este momento, the machine exhaust and the refrigeration system are energizing, and the ammeter shows a value of about 7A;
En segundo lugar, wait 5 to 10 seconds, press the trigger button on the external control panel, the current meter display value is zero, after 3 to 5 seconds, the xenon lamp is ignited, and the ammeter displays the value 7A. (Refer to the laser power supply operating instructions);
En tercer lugar, turn on the galvanometer power supply;
Fourth, turn on the computer and call up the required marking file;
Quinto, adjust the laser power to the working current (10 ~ 18A), you can start marking;
Si quieres aprender más, por favor póngase en contacto con Focuslaser
Correo electrónico: ventas@focuslaser.net
WhatsApp:+8615102000818
