Verifique o circuito e o circuito de água antes de ligá-lo. A sequência de inicialização é:

Primeiramente, turn on the incoming power and turn on the key switch. Neste momento, the machine exhaust and the refrigeration system are energizing, and the ammeter shows a value of about 7A;

Em segundo lugar, wait 5 to 10 seconds, press the trigger button on the external control panel, the current meter display value is zero, after 3 to 5 seconds, the xenon lamp is ignited, and the ammeter displays the value 7A. (Refer to the laser power supply operating instructions);

Em terceiro lugar, turn on the galvanometer power supply;

Fourth, turn on the computer and call up the required marking file;

Quinto, adjust the laser power to the working current (10 ~ 18A), you can start marking;

Se você quiser saber mais, entre em contato com a Focuslaser

E-mail: vendas@focuslaser.net

Whatsapp:+8615102000818